OIT***-F113-B12-CB*
OITControl
19
9165
201
3-
06
49
Changing ISO-on-TCP settings
To change the ISO-on-TCP settings, proceed as follows:
1. Select
Configuration > configure OIT System
.
2. If the window
invalid parameters...
pops up, close it by clicking on
OK
.
3. Go to the tab
RFC1006
:
Figure 8.14
RFC1006
tab
4. Enter the appropriate PLC values into the box
TSAP-Host
.
5. Enter the appropriate OIT-system values into the box
TSAP-OIT
.
6. In order to send the settings to the OIT system, click the button
Write
parameters
in the
OIT system
.
7. In order to close the
parameterization of the OIT system
dialog window,
click on
end
.
Activate TNR
To activate the TNR bit in the STL block of the data telegram to the PLC, proceed
as follows:
1. Select
Configuration > Configure OIT System
.
2. If the window
Invalid parameters...
pops up, close it by clicking on
OK
.
3. Go to the tab
Image/Check
:
Figure 8.15
Image/testing
tab
4. Activate the box
Set TNR bit
in the area
Testing
5. In order to send the settings to the OIT system, click the button
Write
parameters
in the
OIT system
area.
6. In order to close the
Parameterization of the OIT system
dialog window,
click on
end
.