Pepperl+Fuchs F2D0-TI-Ex8.FF Series, Manual, Page: 45 / 48

Temperature Multi-Input Device
Function Block Descriptions
2
017-
05
45
31 Calibration Units Unit used to calibrate the input. It is set
automatically when a calibration starts. Valid
values: mV and Ohm
32 Calibration Mode S, OOS Stipulates the validity of user calibration and turns
the calibration mode on for the input. Supported
values are:
■
User calibration off
■
User calibration on: A calibration error
("Calibration State" reads "Failure") will be
reported as a block configuration error so the
block will not switch to AUTO mode.
■
Execute user calibration
33 Calibration State Shows the state of the user calibration for the input.
Supported values are:
■
Not initialized: No user calibration was carried
out yet. The user calibration cannot be turned
on.
■
Executing: User calibration is being started.
■
OK: A valid user calibration has been executed.
■
Failure: The last user calibration failed. The
values are invalid. The user-calibrated
measurement cannot be turned on. The block
will report a configuration error if "Calibration
Mode" is set to "User calibration on".
■
Wait first: Device is waiting for write on
"Calibration Highest Point" or "Calibration
Lowest Point" as first calibration point.
■
Wait second HI: Device is waiting for write on
"Calibration Highest Point" as second
calibration point.
■
Wait second LO: Device is waiting for write on
"Calibration Lowest Point" as second calibration
point.
■
Sampling HI: Device is measuring HI calibration
value.
■
Sampling LO: Device is measuring LO
calibration value.
34 Calibration
Location
S, W, NF Shows location of the last calibration for the input.
35 Calibration Date S, W, NF Shows date of the last calibration for the input.
36 Calibration Who S, W, NF Shows name of person responsible for the last
calibration for the input.
Table 7.4 TI_SENS block (AI) parameter list
Rel.
Index Parameter Units Description