Authentication
Select from
By Remote ID Only
,
Preshared Key
. When selecting
By Remote ID
Only
, be sure to enter a unique peer ID number in the
Remote ID
field.
Remote ID /
Pre-shared Key
This optional field becomes available when
Remote ID /
Pre-shared Key
is selected
as the Peplink Balance’s VPN
Authentication
method, as explained above.
Pre-shared Key
defines the pre-shared key used for this particular VPN connection.
The VPN connection's session key will be further protected by the pre-shared key.
The connection will be up only if the pre-shared keys on each side match. When the
peer is running firmware 5.0+, this setting will be ignored.
NAT Mode
Check this box to allow the local DHCP server to assign an IP address to the remote
peer. When
NAT Mode
is enabled, all remote traffic over the VPN will be tagged with
the assigned IP address using network address translation.
Remote IP
Address / Host
Names
(Optional)
If
NAT Mode
is not enabled, you can enter a remote peer’s WAN IP address or
hostname(s) here. If the remote uses more than one address, enter only one of them
here. Multiple hostnames are allowed and can be separated by a space character or
carriage return. Dynamic-DNS host names are also accepted.
This field is optional. With this field filled, the Peplink Balance will initiate
connection to each of the remote IP addresses until it succeeds in making a
connection. If the field is empty, the Peplink Balance will wait for connection from
the remote peer. Therefore, at least one of the two VPN peers must specify this value.
Otherwise, VPN connections cannot be established.
Data Port
This field is used to specify a UDP port number for transporting outgoing VPN data. If
Default
is selected, UDP port 4500 will be used. Port 32015 will be used if the
remote unit uses Firmware prior to version 5.4 or if port 4500 is unavailable. If
Custom
is selected, enter an outgoing port number from 1 to 65535.
Bandwidth
Limit
Define maximum download and upload speed to each individual peer. This
functionality requires the peer to use PepVPN version 4.0.0 or above.
Cost
Define path cost for this profile.
OSPF will determine the best route through the network using the assigned cost.
Default: 10
8 Port Forwarding
pepwave device connector can act as a firewall that blocks, by default, all inbound
access from the internet. By using port forwarding, Internet users can access servers
behind the pepwave router. Inbound port forwarding rules can be defined at
Advanced>Port Forwarding.
To define a new service, click
Add Service.
Summary of Contents for Pepwave DCS-RUG
Page 53: ......
Page 54: ...12 5 4 Monthly All WAN Monthly Bandwidth Usage...
