63
Table of Error Code (SR Gain adjustment)
When adjustment error is occurred, below screen will be displayed.
[Table of Error Code for Gain adjustment] (aa-bb-xx)
7683
“bb-xx”pture check (X axis)”と同じ
“bb-xx”は“01(aa) Initial capture check (X axis)”と同じ
“bb-xx”は“01(aa) Initial capture check (X axis)”と同じ
00 initialization
01 Read configuration file
01
Can't found setting file.
01
Can't Power on
02 Initialize USB
02, 03 Command error (Communication error)
04
Can't use this program (This program for another model)
03 Initial setting
xx
Command error (Communication error)
01 Initial capture check (X axis)
01-06 Command error (Communication error)
07
SW error (Manual mode)
08-10 Command error (Communication error)
01 Initial setting
11
SW error (MF mode)
12
Command error (Communication error)
13
SW error (SR SW)
14
Command error (Communication error)
02 Config setting
xx
Command error (Communication error)
03 Set initial data
xx
Command error (Communication error)
04 Read initial data
01
Command error (Communication error)
05 Set ram data for SR
xx
Command error (Communication error)
06 Camera release
xx
Command error (Communication error)
07 Get capture data
01, 02 Command error (Communication error)
03
Can't display capture image
01
Initial image is out of spec (X axis)
08 Display capture data
02
Check image is out of spec (X axis)
03
Initial image is out of spec (Y axis)
04
Check image is out of spec (Y axis)
02 Sensitivity Adjustment (Gyro X)
01 Set initial data
xx
Command error (Communication error)
02 Get gyro position data (X data)
xx
Command error (Communication error)
03 Calculate
01
Gyro wave data is something wrong (X data)
02
Gyro wave data is something wrong (Y data)
04 Write gyro sensitivity data (X axis)
xx
Command error (Communication error)
03 Capture check (X axis)
04 Prepare to remove USB
01 USB clear up
xx
Command error (Communication error)
05 initialization
01
Can't Power on
02 Initialize USB
02, 03 Command error (Communication error)
04
Can't use this program (This program for another model)
03 Initial setting
xx
Command error (Communication error)
06 Initial capture check (Y axis)
07 Sensitivity Adjustment (Gyro Y)
01 Set initial data
xx
Command error (Communication error)
02 Get gyro position data (X data)
xx
Command error (Communication error)
03 Calculate
01
Gyro wave data is something wrong (X data)
02
Gyro wave data is something wrong (Y data)
04 Write gyro sensitivity data (X axis)
xx
Command error (Communication error)
08 Capture check (Y axis)
09 Prepare to remove USB
01 USB clear up
xx
Command error (Communication error)
(aa)
(xx)
(bb)
“bb - xx” is same as a table of “01(aa) Initial capture check (X axis)”.
“bb - xx” is same as a table of “01(aa) Initial capture check (X axis)”.
“bb - xx” is same as a table of “01(aa) Initial capture check (X axis)”.
[bb-xx] is the same as “01(aa) Initial capture check (X axis)”
[bb-xx] is the same as “01(aa) Initial capture check (X axis)”
[bb-xx] is the same as “01(aa) Initial capture check (X axis)”