49
⑨
When [+/-] button is pressed, light on the back light of LCD panel and exposure compensation can be set.
⑩
When press AE-L button, AE lock can be set
⑪
When press exposure bracket button, it can be set.
⑫
When press RAW button, [RAW+] should be displayed on LCD panel and it turn off with pressing
ROW button again.
27-5. Shooting and Playback check
①
Turn the main SW to OFF and insert the SD card (for Taking picture) into the camera.
②
Turn the main SW ON
③
Press the MENU button and format the SD card according to indication of LCD monitor.
④
Set the Quality level and Recorded pixels to the default setting and
take three pictures. (Quality Level:
☆☆☆
, Recorded Pixels: 10M)
⑤
Press the Playback button and confirm the image quality.
⑥
When the INFO button is pressed during playback, the camera must switch from
Normal Playback Screen to Histogram Display.
⑦
When the INFO button is pressed again, the camera must switch from Histogram
Display to Detailed Information display.
⑧
Take the picture with vertical position. (Set Grip side on top and bottom)
⑨
Capture the image and confirm the images are displayed correct angle.
⑩
Press the Delete button twice, and then delete all images by the four-way controller key and OK button.
⑪
Turn the main SW to OFF and remove the SD card from the camera.
27-6. Flash Check
①
The built-in flash pops up when the flash button is pressed. And, must be appeared in the
viewfinder and on the LCD panel when flash is fully charged.
②
The flash must be discharged when taking a picture in low light condition.
③
The built-in flash must be retracted firmly when flush is pushed down by finger.
*If flash does not retract properly or too much gap (more than 0.2mm), follow the [Adjustment of flash
retract position].
④
Confirm that must be appeared and discharged when an external flash is attached.
27-7. Adjustment of flash retract position
[Preparation]
: Hexagonal driver 0.9mm (HD-M0.9)
①
There should be approx 0.1mm between a and b when push down the flash.
②
It can be adjusted by turning the adjusting screw, refer to the picture.
③
Apply screw lock to the adjusting screw.
0.1mm
a b
①
b
a
SL
②
ADJ.
③