Filtration control:
- By calculating the time according to the pool temperature (automatic mode).
- By programming a 24 hour cycle (makes it possible to benefit from off hours).
- By integrating the frost protection function (activation of the filtration below 3°C, modifiable
value).
- By giving priority to the heating (if the value of this reference exceeds the set value, and if the
filtration is cut, filtration starts in the next 15 minutes).
- Possibility to select the start time and end time of the filtration in automatic mode (to prevent
noise at night). If SPEEDEO is connected to a SOLEO, this function is found on SOLEO.
- Possibility to increase or reduce the filtration time according to the use of the swimming pool
(economical mode = pool with a low number of visitors, turbo mode = pool with a high number of
visitors) or by d or - 30% (value can be adjusted).
- Possibility to change into “SHOCK” mode (forcing of the filtration and electrolyser for 24 hours).
- Possibility to change the speed according to the position of the pool cover (motorised cover) if
there is a position contact connection on the dedicated inlet.
- Possibility to change the speed according to the position of a command (interrupter, end
position sensor of the motorised cover).
Control of 3 devices:
- By synchronisation with operation of the pump (each connected device will only be authorised
to operate if the filtration runs at a sufficient rate).
SPEEDEO also makes it possible to visualise, on its screen (in the technical room):
- time
- water temperature
- operating speed (S1 to S4)
- status of the 3 outlets (S1 S2 S3, ON or OFF)
- air temperature (if second sensor present)
THEREFORE IN SUMMER AND WINTER, YOU NO LONGER NEED TO WORRY ABOUT YOUR
FILTRATION AND YOU LIMIT THE INTERVENTIONS IN THE TECHNICAL ROOM TO A BARE
MINIMUM.
Functions
05
Summary of Contents for SPEEDEO SB-PF-SPO-003C
Page 31: ......
