Pentair Siata V132 SFE, Installer Manual

Page: 48 / 88

Installer manual Siata V132 - SFE - Programming
48 / 88 Ref. MKT-IM-003 / B - 19.04.2017
where :
•
d.xxx : incoming water hardness, in French degrees [°f] or [ppm];
• do.xx: desired outgoing water hardness, in French degrees [°f];
• C:xx: exchange capacity of the regenerating resin used, expressed in [°f x m
3
/L] or in [g/L
resin
] of
CaCO
3
;
• L.xxx: volume of resin, expressed in liters [L].
The result must be typed, rounded down to the closest integer.
Note

The desired outgoing water hardness value must be compatible with the provisions of the
regulations in force where the controller is used.
Duration of the first regeneration cycle stop
Set the duration of the first regeneration cycle stop (minutes). If the
parameter is set to off, the stop will be skipped and the system will
go directly to the next stop.
A Use and to edit this parameter.
B Press to validate and switch to the next parameters.
Duration of the second regeneration cycle stop
Set the duration of the second regeneration cycle stop (minutes). If
the parameter is set to off, the stop will be skipped and the system
will go directly to the next stop.
A Use and to edit this parameter.
B Press to validate and switch to the next parameters.
Duration of the third regeneration cycle stop
Set the duration of the third regeneration cycle stop (minutes). If the
parameter is set to off, the stop will be skipped and the system will
go directly to the next stop.
A Use and to edit this parameter.
B Press to validate and switch to the next parameters.
Duration of the fourth regeneration cycle stop
Set the duration of the fourth regeneration cycle stop (minutes). If the
parameter is set to off, the stop will be skipped and the system will
go directly to the next stop.
A Use and to edit this parameter.
B Press to validate and switch to the next parameters.
A