Page 48
Setting up MagicStream Laminars
The MagicStream
®
Laminar provide a clear, turbulence-free stream of water that is lit with a fiber optic
cable, or an LED light for a dazzling nighttime effect. The 12 VAC powered LED light can generate a series
of multicoloured light shows, or can be set to display a continuous, single colour. If desired, the built-in
solenoid “thumper” can create a random “wrinkle,” in the Laminar’s stream, causing it to display a brilliant
spot of light that moves along the stream’s arc. The light enhancer can be adjusted to maximize the light in
the arc.
Up to twelve (12) MagicStream Laminar circuits can be displayed on the main Lights screen, assuming each
laminar has its own relay and separate circuit.. From the Lights screen you can activate the MagicStream
laminars (changing colour modes, turn Thumper on/off, Hold and Reset).
MAGICSTREAM LAMINARS CAN BE CONFIGURED AS EITHER INTELLIBRITE OR MAGICSTREAM. REFER
TO THE MAGICSTREAM INSTRUCTION MANUAL FOR DETAILS ON SETTING MODE.
Setting up MagicStream Laminar LED Lights
To setup MagicStream laminar circuits, first assign each laminar auxiliary relay circuit a circuit name (see
“Circuit Names” page 28, then assigned the laminar relay circuit name to “MAGICSTREAM” in the circuit
functions menu (Circuit Func.).
Using the MagicStream Laminar Features
The MagicStream laminar features are displayed in the MagicStream menu. Each time a MagicStream
laminar feature is activated, it resumes with the same features in operation as when last switched off. The
MagicStream features are as follows:
Down button:
Choose MagicStream.
Right button:
Select
MagicStream
.
Up/Down button:
Select the desired MagicStream laminar features.
Right button:
Use this button to activate the selected MagicStream laminar
feature. After the button is pressed, the following screen displays the name
of the selected feature (indicating that the MagicStream feature has been
activated) then returns to the MagicStream feature menu.
Toggle Thumper - Pressing this button creates a “wrinkle” in the laminar stream,
producing a brilliant spot of light in the laminar arc.
Hold -
Select Hold to capture the current colour effect while colours are
changing. The colours will stop changing. Selecting Hold again will resume the
colour changing mode.
Reset - Pressing this button reverts to the
Random
colour changing mode with
the Thumper ON.
Change Mode
-
Pressing this button (each successive OFF/ON combination) will
cycle through
Sync,
Random
and
Party
. Colour changing mode - The colour of
the light changes automatically, according to one the following three programs:
Sync - Colours will change at ten second intervals. In this mode, multiple
laminars will synchronize colours together. Note: To sync multiple laminars (two
or more AUX circuits), be sure to define the “MagicStream” circuits in the “Circuit
Functions” menu.
Random - Colours will change at ten (10) second intervals in a random sequence.
In this mode, multiple laminars will NOT synchronize colours together.
Party - Colours will change randomly and slowly at first, then speed up, until
the sequence ends with quick flashes and strobes. The sequence then repeats,
beginning with the slow changes. In this mode, multiple Laminars will NOT
synchronize colours together.
MENU
LIGHTS
LIGHTS
Getting There
All On
All Off
Sync
MagicStream
Toggle Thumper
Hold
Reset
Change Mode
Change Mode
Advanced Settings: Lights
