Page 22
Controls and buttons (Continued)
Menu/back button:
Use this button to access, save and exit from a current menu or sub-menu
settings. Also, while in a menu or sub-menu items, use this button to go back to a previous
menu level or item. If no menu activity is detected after five minutes, the main screen is
displayed. All menu settings are permanently saved and retained in the control panel even
after power is removed from the control panel. Control panel buttons are disabled while in the
menu mode.
Right button:
When in pool or spa mode use the Left and Right button to adjust the temperature
level. Press the Right button to raise the set point water temperature. Press the Filter Pump
(F) button to display the current water temperature. Use the Right button to select a sub-menu
item for editing. After pressing the Menu button to access the main menu items, use the Right
button to select the menu item and access the sub-menu items for adjustment. While editing a
settings, press and hold the Right button to fast forward through settings and values.
Filter Pump (F) button/LED:
Switches a single speed filter pump on and off in “Pool” or “Spa”
mode. Press the Valves (V) button to toggle between “Pool” and “Spa” mode and rotate valves.
If “Heater” is enabled in the “Heat” menu (see page 25), pressing the Filter Pump button will
also enable the selected heat source (Heater/Solar LED on). The default time before the filter
pump will switch off is 12 hours. This button operates in “Auto” or “Service” mode.
Single-Speed Filter Pump:
If the pump is currently off, press the Filter Pump button (LED on)
to switch the pump on. Press the Filter Pump button again to switch the pump off. However, if
the heater is operating, and a delay is enabled for valves, this allows the heater to cool down
(heater cool-down), then when you press the F button to switch off the pump, only the heater
will turn off, then the filter pump will automatically switch off after 10 minutes to allow the
heater to cool down. Pentair heaters do not require a cool down time. To override the “heater
cool-down,” press the Filter Pump button again to switch off the pump.
Two-Speed Filter Pump:
Press the Filter Pump button (LED on) to switch the two-speed pump on
in high speed. If you switch the pump off to low speed shortly after switching it to high speed,
the filter pump will automatically remain in high speed for a few minutes before switching back
to low speed to allow the pump to prime and establish normal water flow. In order to use the
“2-Speed Pump” menu assignments (see page 46), the 2-Speed relay option must be installed
in the EasyTouch Load Center.
Mode button:
Use this button for service purposes to manually control the EasyTouch system.
Press this button once activate “Service” mode, to allow AUX circuit buttons, Filter Pump,
Valves, Heater and Solar buttons to be operated manually. Press the button a second time to
enable “Time-out” mode. This mode is similar to “Service” mode except that the system will
automatically return to normal operation (Auto) after three hours. Press the button a third time
to return the system to “AUTO” mode. The current operating status is shown in the LCD display.
The menu buttons, remote controllers, and menu scheduled operations are disabled (except
for switching off equipment manually for emergencies) while the system is in “Service” mode.
Auto:
In Auto
(automatic) mode the system is in normal operating mode and is controlled by the
main control panel LCD menu features.
Service:
Use this mode to service pool equipment and to operate equipment manually.
Time-out:
Same functionality as “Service” mode, except that the system will automatically
return to normal operation (Auto) after three hours.
MENU
Controls
