One Shot Mode
Another method of limiting loop playback is achieved by enabling
Buffre One Shot Mode. While similar to disabling Loop On, the One-
Shot Mode button differs in terms of controls and response. With One
Shot Mode enabled, the trigger needs only to be touched momentarily
to engage the loop engine. At the end of the playback cycle, incoming
audio passes through normally.
One Shot Mode is more suited for performance configurations where
you only need to tap the trigger and move on. For example, set Buffre
to Past Playback with Reverse, and then click on the Manual Trigger
button to engage a one shot reverse sweep.
C One Shot
It’s important to note that you will hear no effect when One Shot Mode is enabled in
Current Playback Mode. When triggered under these conditions, a segment of audio
passes directly to the main and FX Send outputs. If you’re only monitoring the main
outputs, you will hear no audible difference, however when used in conjunction with the
FX Sends, this is very useful for sending audio bursts to other devices.
With this configuration, Buffre can be used as momentary FX gate control. Refer to the
example,
Triggered FX Sends
.
v1.0.2 operation manual
15
External FX: Echo, Alligator, etc!
