PDI-P26, 32, 40 TV Installation Guide
Page 33 of 52
Communication Systems Inc.
Better Solutions Are Within Reach™
INSTALLATION and OPERATING INSTRUCTIONS
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH +1-937-743-6010 PH +1-937-743-5664
Document Number: PD196I127R1.DOC
Inactive Power Off (h:mm)
The TV will automatically power off after a specific period of viewer inactivity, providing energy savings.
1.
Enter the Features menu
2.
Press
▲
or
▼
to highlight Power Management.
3.
Press
◄
or
►
to select an active time or select Disabled to disable this feature.
4.
Press the SETUP button to return to the previous menu. To exit, press SETUP until the programming menus
disappear.
NOTE:
Auto Power On must be set to Disabled for this function to operate.
Bed A/B
The TV can be controlled by a patient IR remote. The TV offers Bed A and Bed B selectable codes for independent
control of a single television in a two television room. The patient remote can be toggled between Bed A and Bed B
codes by pressing the CODE button (with a paper clip) on the remote.
1.
Enter the Features menu
2.
Press
▲
or
▼
to highlight Bed A/B.
3.
Press
◄
or
►
to select A
or B.
4.
Press the SETUP button to return to the previous menu. To exit, press SETUP until the programming menus
disappear.
5.
Try the patient remote, PD108-427, to make sure it works with the Bed setting.
6.
If it does not, insert a paperclip into the CODE button at the bottom of the remote and hold it in.
7.
Try the remote again.
Caption Text Modes
Teletext can be displayed in addition to Captions. Teletext is not normally broadcast in the USA. Caption Text Modes
should be set to Disabled for TVs operated in the USA.
1.
Enter the Features menu
2.
Press
▲
or
▼
to highlight Caption Text Modes.
3.
Press
◄
or
►
to select Disabled or Enabled.
4.
Press SETUP to return to the previous menu. To exit, press SETUP until the programming menus disappear.
