Operation Systems
Synergy™ Series | FX-ProView™ Control
45
WARNING:
Read all instructions before using the spa. PDC Spas, PDC International assumes no responsibility for
personal injury or property damage sustained by or through the use of this product. When installing and using this equipment
basic safety precautions should always be taken to reduce risk of electrical shock, ensure safe usage, and safeguard the user’s health.
Preparation and Filling
Fill the spa to its correct operating level. Be sure to open all valves and jets in the plumbing system before filling to allow as much air as
possible to escape from the plumbing and the control system during the filling process.
After turning the power on at the main power panel, the top-side panel will display a startup screen.
Priming Mode
After the initial start-up sequence, the control will enter Priming Mode and display a Priming Mode
screen. Only pump icons appear on the priming mode screen. During the priming mode, the heater
is disabled to allow the priming process to be completed without the possibility of energizing the
heater under low-flow or no-flow conditions. Nothing comes on automatically, but the pump(s)
can be energized by selecting the “Jet” buttons. Manually exit Priming Mode by pressing the “Exit”
Button.
Priming the Pumps
As soon as the Priming Mode screen appears on the panel, select the “Jets 1” button once to start Pump 1 in low-speed and then again
to switch to high-speed. Also, select the other pumps, to turn them on. The pumps should be running in high-speed to facilitate priming.
If the pumps have not primed after 2 minutes, and water is not flowing from the jets in the spa, do not allow the pumps to continue to
run. Turn off the pumps and repeat the process. Note: Turning the power off and back on again will initiate a new pump priming session.
Sometimes momentarily turning the pump off and on will help it to prime. Do not do this more than 5 times. If the pump(s) will not
prime, shut off the power to the spa and call for service.
Important: A pump should not be allowed to run without priming for more than 2 minutes. Under NO circumstances should a pump be
allowed to run without priming beyond the end of the 4-5 minute priming mode. Doing so may cause damage to the pump and cause
the system to energize the heater and go into an overheat condition.
Exiting Priming Mode
You can manually exit Priming Mode by navigating to the “Back” button on the Priming Mode Screen. Note that if you do not manually
exit the priming mode as described above, the priming mode will be automatically terminated after 4-5 minutes. Be sure that the
pump(s) have been primed by this time.
Once the system has exited Priming Mode, the top-side panel will display the Main Screen, but the display will not show the
temperature yet, as shown below. This is because the system requires approximately 1 minute of water flowing through the heater to
determine the water temperature and display it.
Synergy™ Series Swim Spa
Pumps
On the Spa Screen, select a “Jets” button once to turn the pump on or off, and to shift between low- and high-speeds if equipped. If left
running, the pump will turn off after a time-out period. The pump 1 low-speed will time out after 30 minutes. The high-speed will
time-out after 15 minutes.
Summary of Contents for Summit SX15
Page 2: ......
Page 75: ...Operation Systems WAVE Wireless Control option 72...
