Manual
8
5.2
Wireless hand-held display unit
1) “
Zero
”
a) When the device is switched on without any load attached to the hook and the display still shows
numbers, press this key to set the device to 0.
b) In the settings this key is used as the up key.
2) “
Tare
”
a) Attach a loop or a container to the hook and press this key when the device displays a stable value.
The display will now show “0” and “N” flashes.
b) Pour the products into the container. The device will now show the net weight of the product.
c) When you remove the products and the container from the hook, the device will display negative
values.
d) In the settings this key is used to switch between the digits.
3) “
Mode
”
Press “MODE” to switch the backlight off and “ENTER” to confirm this.
Press “MODE” twice to get to the setup and “ENTER” to get to the parameter settings. Press “MODE” to
return to measurement mode.
Press “MODE” 3 times. The display will show “dC”. Then press the “ENTER” key to check the battery
level. Press “MODE” to return to measurement mode.
Press “MODE” 4 times. The display will show “Unit”. Then press “ENTER” to get to the mode in which you
can select the unit. Press “Zero” to select the unit and “Mode” to return to measurement mode.
Press “MODE” 5 times. The display will show “ACCU”. Then press “ENTER” to check the memory status.
Press “MODE” to return to measurement mode.
Press “MODE” 6 times. The display will show “SACCU”. Press “ENTER” to search within the memory.
Press “MODE” to return to measurement mode.
Press “MODE” 7 times. The display will show “CLEAr”. Press “ENTER” to delete the memory. Press
“MODE” to return to measurement mode.
Press “MODE” 8 times. The display will show “CLIBr”. Press “ENTER” and hold it for 3 seconds to check
the calibration process. Press “ENTER” and hold I for fewer than 3 seconds to return to measurement
mode.
Press “MODE” 9 times. The display will show “ESC”. Press “ENTER” and “Peak” to return to the default
settings.
4) “
Enter
”
Is used to select a function, normally in combination with the “MODE” key.
5) “
Peak
”
When you attach a new weight and press the PEAK key, the device will show the maximum value of this
new weight and freezes it into the display. By pressing the key again, you return to normal measurement.
