Manual
13
times
error in repeated saving
cannot save the same weight
twice
current number of memory locations
first 4 digits of the saved value
actual weight = first 4 last
4 digits
last 4 digits of the saved value
actual weight = first 4 last
4 digits
question whether you are sure that you want to
delete the memory
if not, stop the deletion process
deletion stopped
deletion confirmed
value is too high
value is too low
no value saved
appears when you check the
memory
overload warning
overload warning
battery warning
after 1 min. automatic switch-off
battery voltage
end
finish parameter setting or
calibration
switch-off
weight attached before STB light flashes
5.6
Troubleshooting
problem
possible reason
solution
no display
batteries defective
replace
key defective
call support
ON / OFF key has not been
pressed properly
press the ON / OFF key firmly for
3 seconds
numbers flash
batteries low
recharge batteries
display does not show new
values when new loads are
attached
defective force transducer
call support
no longer calibrated
re-calibrate
display shows excessive
deflections towards 0 between
weighings
The device has not sufficiently
stabilised after switch-on
allow 3 – 5 minutes to warm up
after switch-on
display shows Error in huge
letters during weighing
device has not been reset to 0
press ZERO before you start
weighing
repeat calibration
see calibration
kg / lb wrong choice
see hand-held device
wireless connection reduced
batteries low
replace batteries
