Manual
10
5.3.7
Delete memory
OPERATION
DISPLAY
Description
Press “Mode” 7 times and
confirm with “Enter”.
question: delete or not?
Press “Mode” to stop.
Press “Enter” to delete.
5.3.8
Battery voltage
OPERATION
DISPLAY
Description
Press “Mode” 3 times. Display
shows “dC”. Press “Enter”.
display power battery voltage
Press “Mode”.
back
5.3.9
To change the unit
OPERATION
DISPLAY
Description
Press “Mode”. Select “Unit” and
press “Enter”.
Press “Enter”. The units are
changed every time “Enter” is
pressed.
Press “Mode” again.
back
5.3.10 To return to measurement mode
OPERATION
Description
Press “Mode”. Select “ESC” and
press “Enter”.
to return to measurement mode
5.4
Parameter selection and calibration
You can use the hand-held device to select parameter settings or calibration.
5.4.1
Key functions
Key
Function
“Tare”
to change numbers
“ZERO”
to increase values
“MODE”
to save and exit
“ENTER”
to confirm
5.4.2
Parameter settings
OPERATION
DISPLAY
Description
Press “Mode” twice.
to confirm, open the parameter
settings
Press “Enter”.
device displays capacity in case it
is calibrated
Press “Zero” to select.
select capacity
The display shows
02/03/05/06/10/15/20/30/50/60/75
one after the other. Select cap:
2000 kg and for example FS =02.
Press “Enter” to confirm.
The display shows ld = 02. If the
device is calibrated, it will show
the calibrated range.
Press “Zero” to select.
select division
The display shows
01/02/05/10/20 one after the
other. 2000 kg
The
division is 1 kg, so choose ld =
01.
If the device is new, it will display
Pt = 0. If the device is calibrated,
