Manual
4
This manual is published by PCE Instruments without any guarantee.
We expressly refer to our general guarantee terms, they can be found in our general terms of business.
If you have any questions please contact PCE Instruments.
2.2
Maintenance and inspection
- Inspection ahead of each use of the measuring equipment
When inspecting the equipment before starting work, the user must make sure that
- there are no visible deformations or other damage such as cracks,
- all attachment parts are complete and in good condition (e. g. safety splits etc.)
- the existing complete system does not inherit any hazards (e. g. faulty mounting etc.)
- the environment does not inherit any hazards and if so, that counter measures are taken.
- Regular inspection / maintenance
Every 3 months or 12500 measurements,
whatever happens first.
- Control the wear and tear of the attachment
parts.
- Control all dimensions.
- Consider all possible deformations and damage.
- Make sure that all parts work properly.
Every 12 months or 50000 measurements,
whatever happens first.
- Inspect all load-bearing parts, e. g. check for
hairline cracks etc. Have maintenance carried out
by qualified personnel.
Every 5 years or 250000 measurements, whatever
happens first.
-
All load-bearing parts must be replaced.
Every 10 years or 500000 measurements,
whatever happens first.
- Service life of the equipment is over. Equipment
must be replaced.
Only the owner or user is responsible for damage and injuries resulting from improper use or non-
observance of the regulations. The producer assumes no liability for improper use. The safety notes are
extracts from the valid norms and regulations along with some notes and tips. These do not replace the
valid regulations and norms but must be seen as assistance for safe use of the equipment. Please read
the valid national norms and regulations.
If you have any questions, please contact PCE.
