DCH-4000P-xx series Receivers
- 6 -
W W W . P B I - C H I N A . C O M
5. REAR PANEL
Figure 3.2 Rear Panel of DCH-4000P-xx Series
B1
TS/IP Input/Output interface
B2
XRL L interface
B3
XRL R interface
B4
RGB/YUV interface (G/Y)
B5
RGB/YUV interface (B/U)
B6
RGB/YUV interface (R/Y)
B7
CVBS2 Output interface
B8, B18
ASI2/SDI output interface
B9, B19
ASI1 output interface
B17
ASI input interface
B10 RS-232
interface
B11
Tuner Loop Out interface
B12
Tuner In interface
B13
Power socket, AC 90~260V
B14
CVBS1 Output interface
B15, B16
L-Audio-R interface
B20
Ethernet interface for remote management system
B21 Grounding
5.1 Power Supply
The power cord is inserted to an IEC main socket at the side of the device.
Check that the power cord is suitable for the country where the device will be used.
A standard power cord with a European DIN 49441 two pin main plug is delivered together
with the device.
The line fuses are housed in a small container at the side of the power supply connector.
5.2 Output Connectors
The ASI interface B9), B19) and ASI2 interface B8), B18) are two pairs of independent ASI
output. Both use female BNC connectors, with 75 Ohm impedance. The ASI interface B18)
and B19) are used as a redundant output of B8) and B9) out.
