DCH-4000P-xx series Receivers
- 18 -
W W W . P B I - C H I N A . C O M
Figure 8.4 Inputs Menu Structure for DCH-4000P-41S2
8.2 Setting Inputs for DCH-4000P-41S /-41T/-41C/-41S2
In the Input Menu, you can monitor and configure the parameters of the Tuner.
8.2.1 Checking Status of Inputs
There are 2 displays on the LCD for monitoring the status of input.
- ASI Input:
locked or unlock indicates the ASI input status.
- Tuner Input:
when a satellite signal is locked via the tuner, the bit rate is displayed on the
bottom row of the LCD.
- IP IN:
this indicates the status of the transport stream over IP input. The bitrate is displayed
on the bottom row of the LCD, if IP input is valid.
8.2.2 Setting the Tuner Parameters
Please refer to
paragraph 7.2.2.
8.2.3 Setting the Ethernet Connector
There is an Ethernet connector for receiving transport stream over IP. The Ethernet connector
has user-configurable IP address, network mask and default gateway. These must be set to
appropriate values for the network over which the transport stream over IP is received.
- Source IP Addr:
Enter the IP address for streaming IP input of the unit.
- Source Network
: Enter the network sub mask for the subnet to which the unit is connected
for IP streaming traffic.
- Source Gateway:
Set the gateway for the network to which the unit is connected for IP
streaming traffic.
