DCH-4000P-xx series Receivers
- 23 -
W W W . P B I - C H I N A . C O M
9.3.1 Setting the Ethernet TS over IP output
The Ethernet connector could also be configured as the output of the transport stream over IP.
The parameters listed below must be set to appropriate values for the network over which the
transport stream over IP is broadcasted.
- Stream IP Address:
Enter the IP address for streaming IP output of the unit.
- Stream Network Mask
: Enter the network sub mask for the subnet to which the unit is
connected for IP streaming traffic.
- Stream Gateway:
Set the gateway for the network to which the unit is connected for IP
streaming traffic.
- Stream Mac Address:
factory-set MAC addresses are guaranteed to unique. Therefore you
cannot configure the address.
- Multicast IP address:
Enter the IP address of the multicast stream for the transport stream
over IP output.
-
UDP Port:
Enter the UDP port number of the TS over IP stream output.
- Protocol:
select the protocol for multicast: UDP or RTP.
- TS Pkts Per UDP:
set the number of the TS packages encapsulated in one UDP package.
The valid range goes from 1 to 7.
- Time To Live:
set the number of the routers over which the TS over IP can be transmitted.
The valid range goes from 1 to 5.
- Type of Service:
select the type of service. There are: Normal, Min Monetary Cost, Max
Reliability, Max Throughput or Min Delay optional.
- Source:
select the source of the TS over IP streaming output. There are: ASI Input, CI
De-encrypted or TUNER.
9.3.2 Other output settings for DCH-4000P-42S /-42T/-42C/-42S2
Please refer to
paragraph 7.3
for the other output setting method.
10. REMOTE MONITORING AND CONTROL
The DCH-4000P-xx series provides an Ethernet remote control interface for user remote
control or supervise one or multiple DCH-4000P-xx via the Headend Devices Management
System (HDMS).
10.1 Install HDMS to a PC
The HDMS Installation.exe file could be found on the CD-ROM which is enclosed in the
original package. Detailed information about installation can be found in the
HDMS Reference
Guide
.
10.2 Connect to HDMS
After installation of HDMS, you need to configure the local settings of the DCH-4000P-xx (s)
which is/are expected to connect to the remote control network. Please refer to
paragraph 6.2.1.
