PAW FC4.13, Manual For Specialised Craftsman

Page: 26 / 36

26
en
3.8 Manual mode
In the Manual mode menu, the operating mode of all relays on the controller and
of all PWM outputs in use can be adjusted.
If the operating mode for HE1 or HE2 respectively is set to On, Off or Auto, this
will only affect the speed control signal sent to the pump via PWM output 1 or 2
respectively. The 100 % power supply to the pump is kept up by the L' connection.
Operating modes for HE1 and HE2:
On = 100 % power supply via L', 100 % pump speed signal via PWM output
Auto = 100 % power supply via L', fl exible pump speed signal via PWM output
Off = 100 % power supply via L', 0 % pump speed signal via PWM output
The operating mode can be selected for each individual relay, too. The following
modes are available for all relays:
Off = Relay is switched off (manual mode)
Auto = Relay is in automatic mode
On = Relay active at 100 % speed (manual mode)
Note:
After service and maintenance work, the relay mode must be set back to
Auto. Otherwise normal operation will not be possible.
Stopping the logging
Î Select the menu item Remove card…
Î
After Remove card is displayed, remove the card from the slot.
When Linear is adjusted in the Logging type adjustment channel, data logging
will stop if the capacity limit is reached. The message Card full will be displayed.
If Cyclic is adjusted, the oldest data logged onto the SD card will be overwritten as
soon as the capacity limit is reached.
Note:
Because of the increasing size of the data packets, the remaining logging
time does not decrease linearly. The data packet size can increase, e. g. with
the increasing operating hours value.
Storing controller adjustments
Î
To store the controller adjustments on an SD card, select the menu item Save
adjustments.
While the adjustments are being stored, fi rst Please wait, then Done! will be indicat-
ed on the display. The controller adjustments are stored as a .SET fi le on the SD card.
Loading controller adjustments
Î To load controller adjustments from an SD card, select the menu item Load
adjustments.
The File selection window is indicated.
Î Select the desired .SET fi le.
While the adjustments are being loaded, fi rst Please wait, then Done! will be
indicated on the display.
Formatting the SD card
Î Select the menu item Format card.
The content of the card will be deleted and the card will be formatted with the
FAT fi le system.
Note:
To safely remove the SD card, always select the menu item Remove
card … before removing the card.
SD card
Adjustment channel Description Adjustment range / selection Factory setting
Remove card… Safely remove card - -
Save adjustments Save adjustments - -
Load adjustments Load adjustments - -
Logging interval Logging interval 00:01 … 20:00 (mm:ss) 01:00
Logging type Logging type Cyclic, Linear Linear
Format card Format card - -