Installing the IpChannel Bank
28
SmartNode 4900 User Manual
3 • Hardware installation
Note
When setting up your SmartNode you must consider cable-length
limitations and potential electromagnetic interference (EMI) as
defined by the applicable local and international regulations. Ensure
that your site is properly prepared before beginning installation.
Location and mounting requirements
The SmartNode 4900 is intended to be placed on a desktop or similar sturdy, flat surface that offers easy access
to the cables or be installed in a standard 19-inch rack chassis. Allow sufficient space at the rear of the chassis
for cable connections. Additionally, you should consider the need to access the unit for future upgrades
and maintenance.
This completes the planning phase for installation. The next section begins the installation procedures.
Installing the IpChannel Bank
Unpacking the Model SN4900 series IpChannel Bank
Inspect the shipping carton for external damage. Note any damage before removing the container contents.
Report any equipment damage to the shipping carrier immediately for claim purposes. Save all packing mate-
rial in case you need to return an item to the factory for servicing.
The IpChannel Bank comes with the following items:
•
Model SN4900 Series IpChannel Bank Quick Start Guide
•
Model SN4900 Series IpChannel Bank
•
An RJ-45-to-RJ-45 cable for use with the console and Ethernet ports
•
A DB-9-to-RJ-45 (EIA-561) adapter for connecting a PC’s serial port to the IpChannel Bank console port
•
Rack mounting kit with rack ears and mounting hardware
Note
Power cables are shipped separately from the Model SN4900 Series
IpChannel Bank
Note
Contact Patton Electronics for the proper RJ-21X cable for the
FSX ports
IpChannel Bank chassis installation
Do the following:
1.
If you have not done so already, remove the IpChannel Bank from its shipping container.
2.
If you are installing the IpChannel Bank in a 19-inch rack, go to step
4
. Otherwise, place the IpChannel
Bank at the desired location.
3.
Go to section
“Connecting cables”
on page 29
4.
Install the rack mounting ears onto the IpChannel Bank using the mounting hardware provided.
5.
Place the IpChannel Bank at the desired position in the rack.
Summary of Contents for SmartNode 4900
Page 46: ...46 Chapter 5 LEDs status and monitoring Chapter contents Status LEDs 47 ...
Page 68: ...68 Appendix D Factory Configuration Chapter contents Introduction 68 ...
Page 73: ...73 Appendix F Installation checklist Chapter contents Introduction 73 ...
Page 75: ...75 Appendix G Accessories Chapter contents Introduction 75 ...
