2. Connect the IPLink VPN Router to the network
44
IPLink 2800 Series Getting Started Guide
3 • Getting started with the IPLink Managed VPN Router
2. Connect the IPLink VPN Router to the network
Depending whether you connect the IPLink VPN Router to a host directly or via a hub or switch either
straight-through wired or cross-over cables must be used (see
Figure 11. Connecting the IPLink VPN Router to the network
You can check the connection with the ping command to another host on the local LAN.
172.16.1.99(if-ip)[eth0]#ping <IP Address of the host>
Respectively from the host: ping 172.16.1.99
Note
To ping outside your local LAN, you will need to configure the
default gateway.
3. Load configuration
Patton provides a collection of configuration templates on the CD-ROM that came with the IPLink device,
one of which may be similar enough to your application that you can use it to speed up configuring the IPLink
router. Simply download the configuration note that matches your application to your PC. Adapt the configu-
ration as described in the configuration note to your network (remember to modify the IP address) and copy
the modified configuration to a TFTP server. The IPLink VPN Router can now load its configuration from
this server.
In this example we assume the TFTP server on the host with the IP address 172.16.1.11 and the configuration
named IPL.cfg in the root directory of the TFTP server.
172.16.1.99(if-ip)[eth0]#copy tftp://172.16.1.11/IPL.cfg startup-config
Download...100%
172.16.1.99(if-ip)[eth0]#
Network
interface
ETH 0
Cross-over cable
IPLink Router
Host
Network
interface
ETH 0
Straight-through
wired cable
IPLink Router
Host
Hub
Straight-through
wired cable
Link
100M
Activity
Enet 0
IPLink VPN
Router
Run
Link
100M
Activity
Enet 1
P
ower
Console
Link
100M
Activity
Enet 0
IPLink VPN
Router
Run
Link
100M
Activity
Enet 1
P
ower
Console
Summary of Contents for IPLink 2821
