![background image](http://html1.mh-extra.com/html/patton-electronics/iplink-2821/iplink-2821_getting-started-manual_4067682029.webp)
Planning the installation
29
IPLink 2800 Series Getting Started Guide
2 • Hardware installation
Planning the installation
Before you start the actual installation, we strongly recommend that you gather all the information you will
need to install and setup the device. See
for an example of what pre-installment checks you might need
to carry out. Completing the pre-installation checks enables you to install and set up your VPN router within
an existing network infrastructure with confidence.
Note
When setting up your VPN router you must consider cable length
limitations, and potential electromagnetic interference (EMI) as
defined by the applicable local and international regulations. Ensure
that your site is properly prepared before beginning installation.
Before installing the VPN Router device, the following tasks should be completed:
•
Create a network diagram (see section
•
Gather IP related information (see section
on page 31 for more information)
•
Install the hardware and software needed to configure the IPLink router. (See section
•
Verify power source reliability (see section
When you finish preparing for your VPN Router installation, go to section
page 32 to install the device.
The mains outlet that is utilized to power the equipment must be
within 1 meter (3 feet) of the device and shall be easily accessible.
CAUTION
Summary of Contents for IPLink 2821
