![background image](http://html1.mh-extra.com/html/patton-electronics/iplink-2821/iplink-2821_getting-started-manual_4067682093.webp)
Access control list configuration task list
93
IPLink 2800 Series Getting Started Guide
7 • Access control list configuration
Mode: Interface
Where the syntax is:
Example:
Debugging access control list profiles
The following example shows how to enable debugging for incoming traffic of access control lists on interface
wan. On level 7 all debug output is shown.
2800(cfg)#context ip router
2800(cfg-ip)[router]#interface wan
2800(cfg-if)[wan]#debug acl in 7
The following example enables the debug monitor for access control lists globally.
2800#debug acl
The following example disables the debug monitor for access control lists globally.
2800#no debug acl
Step
Command
Purpose
1
node(cfg)#context ip router
Selects the IP router context
2
node(ctx-ip)[router]#interface
if-name
Selects IP interface
if-name for which access
control list profile shall be debugged
3
node(if-ip)[
if-name
]#debug acl {in | out} [level]
Enables access control list debug monitor
with a certain debug level for the selected
interface
if-name
Keyword
Meaning
if-name
The name of the IP interface to which an access control list profile gets bound
level
The detail level. Level 0 disables all debug output, level 7 shows all debug output.
in
Specifies that the settings for incoming packets are to be changed.
out
Specifies that the settings for outgoing packets are to be changed.
Summary of Contents for IPLink 2821
