![background image](http://html1.mh-extra.com/html/patton-electronics/iplink-2821/iplink-2821_getting-started-manual_4067682035.webp)
Installing the VPN router
35
IPLink 2800 Series Getting Started Guide
2 • Hardware installation
The router’s V.35 interface is wired as a DTE. No DCE configuration is possible. If you are directly connecting
the router’s V.35 interface to third-party equipment that cannot be configured as a DCE, you must use a tail-
circuit cable. You can purchase a tail-circuit cable from a datacom-supply vendor. A tail-circuit cable will cross-
over the necessary V.35 signals so that the two DTE interfaces can communicate.
Note
Some third-party equipment will not be able to work properly in
DTE-to-DTE configurations even when using a tail-circuit cable.
Please refer to your third party equipment user manual for informa-
tion on DTE-to DTE operation.
The router’s V.35 interface requires a cable with a male DB-25 connector. Attach the male DB-25/M35 con-
nector of the V.35 cable to the female DB-25 connector on the router. Attach the other end of the cable to the
V.35 connector on local V.35 modem or multiplexer device.
Installing the X.21 interface cable. The IPLink Model 2821 comes with a V.35 interface presented on a DB-
25 female connector (see
Figure 3. Rear view of the router showing location of X.21 interface connector
X.21 serial port connector
Summary of Contents for IPLink 2821
