Minden Machine Shop Inc.
1302 K Road Minden, NE
800-264-6587 / 308-832-0220
Outside Fore/Aft Cylinder Hose Placement
1.
The supply hoses for the fore/aft cylinders has already been connected from the step in the "Inside Fore/Aft Cylinder Hose Placement."
2.
Locate the 1/4" x 130-1/2" hoses with the white tie. These are hose 7 and hose 9. Connect one end of hose 7 to the ram end fitting of the
right outside fore/aft cylinder and then connect the other end to outlet 3 in the right flow divider. Next, connect one end of hose 9 to the
ram end fitting of the left outside fore/aft cylinder and then connect the other end to outlet 1 of the left flow divider. Refer to Detail A
and machine diagram on the previous page to install the hoses correctly.
3.
Locate the 1/4" x 117-1/2" hoses marked with a red tie. These are hose 8 and hose 10. Connect one end of hose 8 to the lower fitting of
the right outside fore/aft cylinder and then connect the other end to the cross fitting at the center of the rear tube. Next, connect one end
of hose 10 to the lower fitting of the left outside fore/aft cylinder and connect the other end to the tee fitting at the center of the rear tube.
See Detail A and the machine diagram on the previous page for assistance with the hose connections.
4.
Be sure to tighten all hose connections and to route the hoses so they will not get pinched or be in the way during operation.
5.
When the hydraulic hose installation is complete, tie the hoses in place as they have been routed so they will stay in place and out of the
way during operation. Large ties have been included for this step. Be sure the hoses will not get pinched or be in the way during
operation. Finally, make sure the hoses have enough room so that they can flex with the machine as it is adjusted during operation.
Crop Sweeper V 10.0
54
