Minden Machine Shop Inc.
1302 K Road Minden, NE
800-264-6587 / 308-832-0220
Fore/Aft Cylinder Hose Placement
1.
Port 2, See Detail A on previous page, is the supply port for all of the fore/aft cylinders. Locate the 1/4" x 114-1/2"
hydraulic hoses with a blue tie. Attach hose 2 to the fitting at lower port at Port 2 and the hose 1 to the upper port
fitting at Port 2. See Detail A on previous page for attachment. The ends with the elbows will go towards the center of
the rear bar where the flow divider is located. Please attach the hoses correctly, Hose 2 goes to the flow divider while
hose 1 goes to the tee fitting, see Detail B on the previous page.
2.
Locate the 1/4" x 100-1/2" hydraulic hoses that have a clear tie on them. Select a hose and attach one end to the ram
end fitting on the right fore/aft cylinder and then the other end of this hose will go to outlet 3 on the flow divider, See
Detail B and machine diagram on previous page. Now, attach one end of the other hose to the ram end fitting on the
left fore/aft cylinder and the other end of this hose will be attached to outlet 1 of the flow divider, see Detail B and the
machine diagram on the previous page.
3.
Locate the 1/4" x 93-1/2" hydraulic hoses that have a red tie on them. Select a one of these hoses and attach one end of
the hose to the bottom fitting of the right fore/aft cylinder. Attach the other end of this hose to the tee fitting as shown
in Detail B on the previous page. Next, attach an end of the other hose to the bottom fitting of the left fore/aft cylinder.
Attach the other end of this hose to the cross fitting as shown in Detail B on the previous page.
4.
Be sure to route all hoses so they will not get pinched and will be out of the way during operation.
Crop Sweeper V 10.0
62
