DETAIL A
DETAIL B
A
B
Minden Machine Shop Inc.
1302 K Road Minden, NE
800-264-6587 / 308-832-0220
8 ROW LIFT CYLINDER HOSE PLACEMENT
11 - (BLUE TIE, 210" LONG) R1704A-606606-
21000
12 - (GREEN TIE, 198" LONG) R1704A-606606-
19800
13 - (NO TIE, 22" LONG) R1704A-606606-
02200
14 - (NO TIE, 28" LONG) R1704A-606606-
02800
15 - GO TO STRIPPER PLATES IF EQUIPPED
16 - GO TO STRIPPER PLATES IF EQUIPPED
17 - (NO TIE, 72" LONG) R1706A-606666-
07200
18 - (NO TIE, 72" LONG) R1706A-606666-
07200
Hoses 17 and 18 will connect to the
combine "Stripper Plate" connection
(Single Point Connection)
17
18
11
12
17
18
12
11
12
11
13
14
15
16
1.
Locate the 3/8" x 72" long hoses. These hoses do not have tie with them.
Once located, connect the hoses to the end of the hydraulic block, see
Detail A, hoses 17 and 18. These hoses are the supply hoses for the
hydraulic block and they are connected to the combine's hydraulic system
that controls the fore/aft hydraulic or the hydraulic deck plate control.
This circuit is located at the feeder house of the combine or within the
single point connection on the feeder house if the combine is equipped
with one. On newer systems, the fore/aft control is located on the corn
head as the deck plate control and the hoses will have to be connected
here for correct operation.
2.
The next hoses to be attached will be the lift cylinder hoses. Locate the
1/4" x 210" hydraulic hose with a blue tie (hose 11), and the 1/4" x 198"
hydraulic hose with a green tie (hose 12). These hoses are attached at
port three with the tee fittings, See Detail A and Detail B for their
connection. Be sure to route the hoses so they will not be pinched and
are out of the way.
3.
Locate the 1/4" x 22" long hydraulic hose with no tie (hose 13) and the
1/4" x 28" hydraulic hose with no tie (Hose 14). See Detail A for their
connection.
4.
Port one, see item 15 and 16 in Detail A, will supply hydraulic oil to the
deck plate or stripper plates if the corn head is equipped with that feature.
If the corn head does not have deck plates/stripper plates or if they are
electric, port one will need to be plugged with the supplied plugs. The
end user will have to get the hoses for this feature.
5.
Corn heads with single acting deck plates will only use the top port and
the bottom port will have to be capped.
6.
Once the hydraulic hoses are installed, be sure to tighten all the
connections.
Crop Sweeper V 10.0
50
