Minden Machine Shop Inc.
1302 K Road Minden, NE
800-264-6587 / 308-832-0220
Inside Fore/Aft Cylinder Hose Placement
1.
Port 2, See Detail B on previous page, is the supply port for all of the fore/aft cylinders. Locate the 1/4" x 114-1/2"
hydraulic hoses with a blue tie. Attach one of the hoses to the fitting at lower port at Port 2 and the other hose to the
upper port fitting at Port 2. See Detail B on previous page for attachment. The ends with the elbows will go towards
the center of the rear bar where the flow dividers are located. Please attach the hoses correctly, Hose 6 goes to the flow
dividers while hose 5 goes to the cross fitting, see Detail A on the previous page.
2.
Locate the 1/4" x 70-1/2" hydraulic hoses that have a clear tie on them. These hoses are listed as hose 1 and hose 4.
Attach one end of hose 1 to the ram end fitting on the inner right fore/aft cylinder and then the other end of hose 1 will
go to outlet 3 on the left side flow divider, See Diagram A and machine diagram on previous page and Detail B on
Hydraulic Fittings Placement page. Now, attach one end of hose 4 to the ram end fitting on the inner left fore/aft
cylinder and the other end of hose 4 will be attached to outlet 1 of the right flow divider, see Detail A and the machine
diagram on the previous page.
3.
Locate the 1/4" x 63-1/2" hydraulic hoses that have a yellow tie on them. These hoses are listed as hose 2 and hose 3.
Attach one end of hose 2 to the bottom fitting of the inner right fore/aft cylinder. Attach the other end of hose 2 to the
tee fitting as shown in Detail A on the previous page. Next, attach one end of hose 3 to the bottom fitting of the inner
left fore/aft cylinder. Attach the other end of hose 3 to the cross fitting as shown in Detail A on the previous page.
4.
Be sure to route all hoses so they will not get pinched and will be out of the way during operation.
Crop Sweeper V 10.0
52
