October 2021
51
PWPP HH P1 - Manual
NETWORK CONFIG
Network Config
NEXT OK ESC
This menu allows the user to configure the IP Address, Subnet Mask and Gateway settings for the device.
Menu Item
Description
IP Address
Manually sets IP address (IPv4).
Use UP and DOWN buttons to edit each octet. Currently selected octet will flash. Press
NEXT button to move to next octet.
After setting the last octet, press NEXT again to SAVE changes, or ESC to cancel.
Subnet Mask
Set subnet mask for the device.
Use UP and DOWN buttons to edit each octet. Currently selected octet will flash. Press
NEXT button to move to next octet.
After setting the last octet, press NEXT again to SAVE changes, or ESC to cancel.
Gateway
Set default gateway for the device.
Use UP and DOWN buttons to edit each octet. Currently selected octet will flash. Press
NEXT button to move to next octet.
After setting the last octet, press NEXT again to SAVE changes, or ESC to cancel.
NOTE
: When IP Mode is set to “Dynamic”, it is still possible to manually adjust the IP settings. This practice is not
recommended as the changes will not stick.
DMX PORT MONITOR
DMX Port Monitor
NEXT OK ESC
This menu item reports DMX input or output levels (depending on the port direction setting).
The top line of the display shows a starting slot number, then four DMX levels. The DMX level closest to the slot number
corresponds to that slot number. Level information is shown as a percentage.
1: 50 75 00 50
UP DOWN ESC
In the example above, the 1: corresponds to DMX Slot 1, which is at 50 percent (8-bit value 128); slot 2 is 75 percent (8-bit
value 192), slot 3 is at 0, and slot 4 is at 50 percent (8-bit value 128).
Pressing the
UP
or
DOWN
button will move the starting slot number by 1 in either direction.
Summary of Contents for Pathport PWPP HH P1 XLR5F
Page 7: ......
