October 2021
5
PWPP HH P1 - Manual
See further sections for information on battery timeout and menu navigation.
RJ45 etherCON
On the left side of the device is the RJ45 etherCON port, which will accept a standard male RJ45 or Neutrik etherCON
connector for connecting to the lighting network. The PWPP HH P1 can be powered via PoE.
The amber LED next to the RJ45 port will glow with link activity.
DMX PORT
On the right side of the device is the DMX port, a 5-pin female locking XLR connector. The female XLR indicates the gateway
is natively a DMX output device, but the port direction can be changed to an Input as well. The green LED next to the DMX
port indicates active DMX input or output, depending on the DMX port direction.
REAR PANEL
Hanging Bracket (Included)
3 Button Interface
RJ45 Ethercon
XLR5F DMX Connector
Battery Compartment
Battery Compartment
Screws (x2)
LCD Screen
Safety Attachment Ring
HANGING BRACKET
As shown above, the rear of the PWPP HH P1 has a mounting location for the hanging bracket. The bracket itself can be
rotated in 90 degree increments to accommodate different device orientations, as needed.
BATTERY COMPARTMENT
The battery compartment is located below the mounting bracket. As shown above, to access the battery for replacement,
remove the two screws and remove the compartment cover. Disconnect the battery from the connector and replace with a
fresh battery, observing the correct polarity.
Summary of Contents for Pathport PWPP HH P1 XLR5F
Page 7: ......
