RP-330 Technical Manual
49
ESC c 3
n
[Name]
Select paper sensor(s) to output paper end signals
[Format]
ASCII
ESC
c
3
n
Hex
1B
63
33
n
Decimal 27
99
51
n
[Range]
0≤
n
≤255
[Description]
Selects the paper sensor(s) to output paper end signals.
·Each bit of
n
is used as follows:
Bit
Off / On
Hex
Decimal
Function
0
Off
00
0
Paper roll near-end sensor disabled
On
01
1
Paper roll near-end sensor enabled
1
Off
00
0
Paper roll near-end sensor disabled
On
02
2
Paper roll near-end sensor enabled
2
Off
00
0
Paper roll end sensor disabled
On
04
4
Paper roll end sensor enabled
3
Off
00
0
Paper roll end sensor disabled
On
08
8
Paper roll end sensor enabled
4 – 7
-
-
-
Undefined
{Details}
·It is possible to select multiple sensors to output signals. Then, if any of
the sensors detects a paper end, the paper end signal is output.
·The command is available only with a parallel interface and is ignored with a serial interface.
·Sensor is switched when executing this command. The paper end signal
switching be delayed depending on the receive buffer state.
·If either bit 0 or bit 1 is on, the paper roll near-end sensor is selected as the paper sensor
outputting paper-end signals
·If either bit 2 or bit 3 is on, the paper roll end sensor is selected as the paper sensor outputting
paper-end signals.
·When all the sensors are disabled, the paper end signal always outputs a paper present status.
[Default]
n
= 15
