Parrot ANAFI USA GOV, User Manual

Page: 114 / 126

114
Touch & Fly: Waypoint
Waypoint is the default Touch & Fly mode. It enables you to fly
ANAFI USA
to any
point on the map. Tap Touch & Fly from the PILOTING MODE box menu. The map
of your surroundings opens full screen. The live image captured by
ANAFI USA
is
minimized in the bottom right corner of your screen.
Tap a point on the map to select a destination for
ANAFI USA
. This point is marked
as a white circle with a green border. For each new Waypoint Touch & Fly session,
FreeFlight 6 asks you to confirm the first destination of
ANAFI USA
as on the
following screen capture. Tap the green TAP HERE TO START box,
ANAFI USA
flies
toward its designated destination. Use the slider on the right of the screen to control
the drone’s altitude (the green figure inside the circle) when it reaches its destination.
Touch & Fly Waypoint: first destination confirmation screen
Important : Activate Touch & Fly Waypoint with care. After the initial confirmation, any
tap on the map will immediately send
ANAFI USA
to the corresponding spot. Parrot
recommends you set your FreeFlight 6 filming or photography options before activating
the Touch & Fly Waypoint mode. If, by mistake, you send
ANAFI USA
toward a
dangerous area, tap the STOP box at the center of the top bar of the HUD, or firmly
reclaim commands from the Parrot Skycontroller USA.
Touch & Fly: POI
To access the POI Touch & Fly option, tap the Type box from the lower bar of the
HUD, and select POI . In POI mode, tap a point on the map to create a point of
interest, marked as a white square diamond with a blue border, labelled with a POI
icon. Control the height of the POI (the blue figure inside the square diamond)
through the slider on the right. This controls the tilt of the gimbal, while you use the
Parrot Skycontroller USA to fly around your target.
ANAFI USA
remains focused on
the POI .