Parker LINKnet AC30P, Hardware Installation Manual

Page: 133 / 176

Compliance
A-7
AC30 series Variable Speed Inverter
RADIATED & CONDUCTED EMISSIONS - COMPLIANCE OVERVIEW
Standard EN 61800-3 Frame K Frame L Frame M Frame N
Radiated Emissions
Category C1 n / a
Category C2
When mounted inside a cubicle with the required attenuation between:
30-1000MHz @ 10dB
Category C3 No specific enclosure required
Conducted Emissions
710
Stacks
Category C1
External EMC filter required.
See page A-8 for inverter emission plots.
Category C2
External EMC filter required.
See page A-8 for inverter emission plots.
Category C3
Where I>=100A
710-4Kxxxx-x E …
product codes.
Maximum motor cable
length 50m.
710-4Lxxxx-x E …
product codes.
Maximum motor cable
length 50m.
710-4Mxxxx-x E …
product codes.
Maximum motor cable
length 50m.
710-4Nxxxx-x E …
product codes.
Maximum motor cable
length 50m.
740
Stacks
Category C3
740-4xxxxx-xN… product codes, when supplied by an AC to DC full bridge and required line choke.
Maximum motor cable length 50m.
Conducted emissions solution true for default, 2kHz switching frequency. Operation at higher switching frequencies will require extra filtering.
WARNING
The drive is suitable for use on both IT and TN supplies when fitted with either the internal filter, or a suitably specified external EMC
filter. However, when used on an IT supply, the filter effectivity is reduced.
For example, if an inverter fitted with an internal C2 filter is on an IT supply, it will now only comply with the higher C3 limits.
Refer to ‘Chapter 4: Installation – Power Stack’ for details on how to remove the Y-cap and VDR disconnects when installing the
product on an IT supply.
Where a solution is required that is not met by the AC30 product range offering, the internal C3 filter emissions’ plots have been provided to allow
specialist EMC filter design companies to tailor a design to meet the customer’s needs.