PARAMOUNT BED cococia Fuka, Instruction Manual

Page: 12 / 36

INSTALLATION
11
J
Use the following procedure to install the air mattress.
1. Installing the air mattress
2. Connecting the air mattress and pump
3. Installing pump
4. Laying power cable
1. Installing the air mattress
J
This air mattress is a body pressure dispersion mattress that is used as an alternative to
general-purpose mattresses. Place it directly on the bed.
z When installing the air mattress, make the bottom of the bed flat and check that there are no
obstacles on the bottom of the bed.
z When installing the air mattress on a bed with mattress stoppers (small) on the left and right
of the bottom, make sure that the snap buttons do not overlap the air mattress stoppers
(small) on the left and right of the bottom.
z This air mattress has a top, bottom, head end, and foot end. When installing the air mattress,
make sure that the product logo faces up and the blowing tube is at the foot end of the user.
z
Check that the CPR valve plug points to
"CLOSE." If it points to "OPEN," turn the
plug to the "CLOSE" position.
WARNING
z
Place the air mattress directly on the bed and do not place anything other
than sheets and mattress pads on the air mattress. The body pressure may
not be dispersed effectively. In addition, when the thickness increases, it is
easier for the user to roll over the bed side-rails, so the user could fall from
the bed or a body part may get caught in the gap between the bed and
bed-side rails, resulting in injury.
z
Install the blowing tube at the foot end. If
the blowing tube is installed at the head
end, the neck may get caught in the
blowing tube, resulting in injury.
z Do not allow the blowing tube to get under
the air mattress. If the blowing tube is bent
or compressed, bedsores may occur.
z Do not use the air mattress in an
environment where combustible anesthetic
gases and high-concentration oxygen may
be present.
There is a risk of explosion or fire.
Plug Plug
No
te!
Air mattress