19
LT5316 (iss 5) 10/10
Flip the slide control lever round so
that the rubber-capped end is
protruding out to the right as shown
in the left-hand picture. Check that it
slides freely up and down in the
nylon slide guides. Remove the
nylock nut with a 7mm A/F spanner
as shown
FOCUS HE SLIMLINE SC
Installation Instructions
SECTION NINE
To Install the Appliance continued
CONNECTING LEVER AND VALVE LINKAGE Continued
SECTION TEN
Checking Operation of Fire
COAL BED LAYOUT
Important: -
Refer to the ‘Heath & Safety Notice located on page 3 of this booklet before laying or replacing any
refractory material.
Note : In the event of replacing coals please use only the specified number of coals as illustrated
– Use coal provided for
this fire only. In the interest of safety and efficiency of your appliance when replacing coals it is essential that the existing
coals are removed and the new coals are replaced correctly as a complete set.
It is important that all the coals and moulded shapes are positioned as shown in these instructions.
IF THE COALS ARE NOT POSITIONED CORRECTLY THIS MAY RESULT IN DAMAGE TO THE GLASS.
LAY COALS AS SHOWN IN SECTION THREE.
Connect the link lever to the stud at the
end of the slide control lever and replace
the nylock nut
. IMPORTANT TURN THE
NUT UNTIL IT JUST TIGHTENS AND
THEN TURN IT BACK A HALF TURN.
Check the operation on the lever and
mechanism ensure that the lever springs
back to the low position when it is released
after pushing
down
Summary of Contents for FOCUS HE SLIMLINE SC
Page 26: ...26 LT5316 iss 5 10 10 ...
Page 27: ...27 LT5316 iss 5 10 10 ...
