Paragon FOCUS HE SLIMLINE SC, Owner'S Manual

Page: 16 / 28

16
LT5316 (iss 5) 10/10
FOCUS HE SLIMLINE SC
Installation Instructions
SECTION NINE To Install the Appliance continued
GLASS PANEL REMOVAL/REFITTING

Lift of the canopy.

Remove the glass fixing clamp secure with two wing nuts and lift it out of the retaining brackets. Take care to support
the glass panel when removing the fixing clamp.

Replace in reverse order making sure that you engage the top and bottom catches properly and that there are no
leaks around the glass seal. Ensure that the glass seal is position correctly (see above) thus minimising its visibility
when the canopy is fitted.

Ensure that the wing nuts are tightened evenly and the glass seal is compressed.
Note: The appliance MUST no be used if the canopy or glass panel is missing or damaged.
CONNECTING THE GAS SUPPLY
Note:- An isolation valve (supplied) should be fitted in the gas supply .This will facilitate servicing.
For a concealed connection: -

After removing the glass panel as described above.

Remove the burner by undoing the two screws in the securing it into the burner support, and lift
the burner away.

Remove carefully the four piece refractory back linings and put safely aside.

Remove the burner engine assembly by undoing the four fixing screws (2 in the engine top and 2
in the engine front) and slide the engine forward to clear the rear location.

Remove the rubber (blind) grommet from the supply pipe inlet hole at the rear of the outer box
and slide the box over the supply pipe. Fix outer box to the surround using one of the methods
described in the next section. Take into account the requirements of BS 6891 1988 dealing with
enclosed pipes.

Refit the grommet over the pipe to ensure the seal around the inlet hole.

Refit the burner engine and make connection between the supply isolating valve and the burner
engine assembly inlet.

For left hand or right hand (unconcealed) front gas connection, remove the appliance engine as
described pervious and fix box to the surround as described in the next section.

Refit the burner and run supply from left or right.
Note: Pipe work in the opening of the fireplace to the rear of the appliance must be suitably wrapped
in accordance with the regulations.