Paragon FOCUS HE SLIMLINE SC, Owner'S Manual

Page: 20 / 28

20
LT5316 (iss 5) 10/10
FOCUS HE SLIMLINE SC
Installation Instructions
SECTION TEN Checking Operation of Fire Continud
CHECKING FOR COMBUSTION PRODUCTS CLEARENCE
IMPORTANT :-The smoke test must be carried out
with the fire starting from cold.

Light the fire and leave at maximum input.

Close all the doors and windows.

After five minutes fit the smoke match in a holder
and position as illustrated with the head of the
match just inside the test opening.

Run the match along the top edge All smoke
must be drawn into the test opening if the
clearance is satisfactory.

If spillage occurs wait a further five minutes and
repeat the test.

Repeat the test with doors open and with any
extractor fans in other rooms in operation.
THE FIRE FRET AND DECORATIVE TRIM
FIT FIRE TRIM AND FRET

Fit the fire with the magnetic strips placed on the vertical side flange of the box.

Offer the decorative trim up squarely and centrally and push into position.

To remove the decorative trim, simply pull away from the magnetic strips.

Fit the fire fret by standing on the hearth in front of the fire. Removal is the reverse of this operation.
ADVISE CUSTOMER THAT:

The glass front of this fire acts as a dress guard, conforming to BS 1945 (1997) and satisfies the heating appliance
regulations (1991) however; a fireguard conforming to BS6539 (1997) must be used to protect young children, the
elderly or infirm.

The curing effect of heating the coals and other refractory components will cause an initial odour. This is due to the
starch used in the manufacturing process and is non-toxic.

The fret is hand cast and some minor imperfections may be found on the surface.

Any debris should be cleaned from the appliance. A vacuum cleaner can be used but only after all the loose coals
have been removed. The appliance should be serviced annually by a competent person in accordance with these
instructions, the flue checked, and the appliance checked for spillage in accordance with the method detailed in these
instructions.

Demonstrate the lighting and extinguishing procedures to the user and the removal and refitting of the brass trim fret
and glass panel for cleaning. Refer to the user section of this booklet.
Hand these instructions over to the user.