1. Network Management Specification
102
June 2004
8000-A2-GB30-30
8.6.1.3
pdnLinkFailureConfigTable.
This object is used to configure failure thresholds before switching over..
8.6.2
Entity redundancy - (PDN-ENTITY-REDUNDANCY-MIB.mib)
This mib is used to configure redundancy features such as Y-cable selection, Trap
generation, etc. This mib is supported read-only even for releases of the DSLAM that does
not support redundancy.
8.6.2.1
pdnEntityRedundancySelection
This object is used to enable/disable the redundancy feature. The default value for this
object is disabled (2)
8.6.2.2
.
pdnYCableSelection
This object is used to enable/disable Y-cable selection. The default value for this object is
disabled (2).
8.6.2.3
pdnRedunGeneralAlarmStatus
This object provides alarm status of the overall redundancy feature.
8.6.2.4
pdnRedunGeneralNotificationEnable
This object allows one to enable/disable the generation of general traps related to the
redundancy feature. By default this object is set to disabled (2).
Table 1-125. Link Failure Config Table
Object
Default Value ( in Seconds)
pdnLinkFailureLOSPeriodBeforeSwitching
3
pdnLinkFailureLOFPeriodBeforeSwitching
3
pdnLinkFailureAISPeriodBeforeSwitching
3
pdnLinkFailureSdPeriodBeforeSwitching
3
pdnLinkFailureSfPeriodBeforeSwitching
3
pdnLinkFailureSdPeriodBeforeSwitching
5
pdnLinkFailureSfPeriodBeforeSwitching
3
Table 1-126. Redundancy MIB objects
Table
Comments
pdnEntityRedundancySelection
Supported as is
pdnYCableSelection
Supported as is
pdnRedunGeneralAlarmStatus
Supported as is
pdnRedunGeneralNotificationEnable
Supported as is
pdnRedunCmdTable
Supported as is
pdnRedunStatusTable
Supported as is
