1. Network Management Specification
8000-A2-GB30-30
June 2004
117
mpeEntPhysicalExtEntityChanged
"Entity has been changed."
SHDSL MIB Traps:
hdsl2ShdslLoopAttenCrossing
" Loop attenuation threshold has been reached/exceeded for the SHDSL segment
endpoint."
hdsl2ShdslSNRMarginCrossing
" SNR margin threshold has been reached/exceeded for the SHDSL segment
endpoint."
hdsl2ShdslPerfESThresh
"Errored Seconds (ES) threshold has been reached/exceeded for the SHDSL
segment endpoint."
hdsl2ShdslPerfSESThresh
"Severely Errored Seconds (SES) threshold has been reached/exceeded for the
SHDSL segment endpoint."
hdsl2ShdslPerfCRCanomaliesThresh
"CRC anomalies threshold has been reached/exceeded for the SHDSL segment
endpoint."
hdsl2ShdslPerfLOSWSThresh
"LOSW seconds threshold has been reached/exceeded for the SHDSL segment
endpoint."
hdsl2ShdslPerfUASThresh
"Unavailable seconds threshold has been reached/exceeded for the SHDSL segment
endpoint."
hdsl2ShdslSpanInvalidNumRepeaters
"Mismatch has been detected between the number of repeater/regenerator units
configured for a SHDSL line and the actual number of repeater/.regenerator
discovered via the EOC."
hdsl2ShdslLoopbackFailure
"Endpoint loopback command failed for an SHDSL segment."
hdsl2ShdslpowerBackoff
"Power Backoff status has changed for this Endpoint."
hdsl2ShdsldeviceFault
"Device Failure status has changed for this Endpoint."
hhdsl2ShdsldcContinuityFault
"dc Continuity Fault status has changed for this Endpoint."
hdsl2ShdslconfigInitFailure
"Config Init Failure status has changed for this Endpoint."
hdsl2ShdslprotocolInitFailure
"Protocol Init Failure status has changed for this Endpoint."
hdsl2ShdslnoNeighborPresent
"No Neighbor Present status has changed for this Endpoint."
hdsl2ShdslLocalPowerLoss
" Impending unit failure due to loss of local power condition has been detected."
Enterprise Specific Traps:
mpeSelfTestFailure
"SelfTest failed"
mpeCcn
"Device Configuration changed."
devSonetStatusChange
"Sonet status (Section, Line or Path) has changed."
pdnRedunEventNoActiveModule
"No module is in the Active state."
pdnRedunEventHwIncompatible
"Redundancy units have hardware incompatibilities."
pdnRedunEventStandbyAlarmOrReset
"Redundancy unit
entPhysicalIndex
is in the Standby/Alarm state."
pdnRedunEventFwIncompatible
"Redundancy units have firmware incompatibilities."
pdnRedunEventCfgIncompatible
"Redundancy units have configuration incompatibilites."
pdnRedunEventLinkDefect
"A link failure condition has been detected on this redundant unit."
Table 1-136. devLastTrapString (2 of 3)
Trap
devLastTrapString
