1. Network Management Specification
8000-A2-GB30-30
June 2004
101
8.5.2.4
pdnMgmtIpPortIfIndex (RC)
The Interface Index of the IP port to which this inverse ARP entry is associated with. Refer
to the pdnMgmtIpPortTable for configuration of IP Ports.
8.5.2.5
pdnMgmtNextHopIp (RC)
The IP address of the unit at the other end of this ATM PVC. This represents the IP Gateway
equivalent for IP traffic on this specific ATM PVC.
8.5.2.6
pdnMgmtAtmInvArpRowStatus (RC)
This object is used to create/delete the ATM inverse ARP entry in this table.
pdnMgmtIpDefaultRouter (RW)
This object identifies the default IP router to use for IP packets with no other known route.
An IP address of 0.0.0.0 would disable and delete the default route from the system.
8.6
Link Fault Management.
This sections describes the mibs associated with the Load sharing, Switchover and
Redundancy Features. This mib is supported read-only even for releases of the DSLAM not
supporting fault switchover, load sharing and redundancy.
8.6.1
Paradyne Enterprise Link Fault Management
(PDN-LINK-FAULT-MGMT-MIB.mib
)
This enterprise mib contains objects to be used for fault management configuration and
control among primary and secondary links.
.
8.6.1.1
pdnLinkFaultMgmtSwitchoverSelection.
This object can not be enable if pdnLinkFaultMgmtApsSelection is enabled. The default
value is disabled (2).
8.6.1.2
pdnDualLinkSelection.
This object is used to enable or disable the ability to split traffic among dual uplinks. The
default value is disabled (2).
Table 1-124. Link Fault Management MIB
Table
Comments
pdnLinkFaultMgmtApsSelection
APS is not supported. Thus this
object is supported
read-only
with
default value of disable (2).
pdnLinkFaultMgmtSwitchoverSelection
Supported as is
pdnDualLinkSelection
Supported as is
pdnLinkFailureConfigTable
Supported as is
