Paradyne Hotwire 7974, User Manual

Page: 57 / 165

Monitoring the Unit
5-3
7970-A2-GB20-00 August 1999
Health and Status Messages
The following messages can appear in the first column of the System and Test
Status screen. The highest priority Health and Status message also appears on
all ATI screens on the bottom right.
Table 5-1. Health and Status Messages (1 of 2)
Message What Message Indicates What To Do
System Operational There are no problems
detected.
LOS at Net, Pt 1 An LOS (Loss Of Signal)
condition has been
detected on the network
interface. 1. Verify that the network cable is
securely attached at both ends.
2. Contact network provider.
Mismatch Rate The LTU, set to Fixed Rate
mode, is attempting to
operate at a DSL line
speed faster than the NTU
can handle. Set the LTU to a DSL line speed
available to the NTU.
NTU/LTU Mismatch The NTU is not configured
the same as the LTU. Configure units to match.
OOF at Net An OOF (Out Of Frame)
condition has been
detected at the network
interface. Contact network provider.
LOS at DSX-1
LOS at G.703 An LOS (Loss Of Signal)
condition has been
detected on the DSX-1 or
G.703 interface. 1. Verify proper framing.
2. Contact network provider.
LOF at DSX-1
LOF at G.703 An LOF (Loss Of Frame)
condition has been
detected on the DSX-1 or
G.703 interface. 1. Verify that the network cable is
securely attached at both ends.
2. Contact network provider.
AIS at DSX-1
AIS at G.703 An Alarm Indication Signal
(AIS) is being received by
the DSX-1 or G.703
interface. 1. Verify that the units line framing
and line coding are compatible.
2. Contact network provider.
EER at Net An EER (Excessive Error
Rate) condition has been
detected on the network
interface at Port 1. The
condition is cleared when
the error rate falls below
the threshold value
currently configured. 1. Ignore condition if 511 test active.
2. Contact network provider.
EER at DSX-1
EER at G.703 An EER (Excessive Error
Rate) condition has been
detected on the DSX-1 or
G.703 interface. 1. Verify the attached equipment
coding is compatible.
2. Contact network provider.