Paradyne Hotwire 7974, User Manual

Page: 11 / 165

vii
7970-A2-GB20-00 August 1999
About This Guide
Document Purpose and Intended Audience
This guide contains information needed to set up, configure, and operate the
Hotwire 7974, 7975, 7976, 7984, 7985, and 7986 Multirate Symmetric Digital
Subscriber Line (M/SDSL) and Multirate High-bit-rate DSL (M/HDSL) Standalone
Termination Units, and is intended for installers and operators.
Document Summary
Section Description
Chapter 1 About the Hotwire 79xx Standalone Termination Unit.
Describes the unit’s features and capabilities.
Chapter 2
Using the Asynchronous Terminal Interface. Provides
instructions for accessing the user interface and navigating
through the screens.
Chapter 3
Initial Startup and Configuration. Provides procedures for
setting up the user interface and for configuring the unit
using the asynchronous terminal interface.
Chapter 4 Configuring the Unit Using the Internal Switches. Provides
procedures for configuring the unit using the internal
switches instead of the asynchronous terminal interface.
Chapter 5 Monitoring the Unit. Describes using the LEDs, status, and
network statistics to monitor the unit.
Chapter 6 Testing. Provides information about available tests and test
setup.
Chapter 7 Messages and Troubleshooting. Provides information on
SNMP traps, device messages, and troubleshooting.
Chapter 8 Security. Presents procedures for creating a login, setting
the effective access levels, and controlling SNMP access.
Chapter 9 IP Addressing. Provides information and examples
regarding IP addresses.