Paradyne Hotwire 7974, User Manual

Page: 28 / 165

Using the Asynchronous Terminal Interface
2-8
7970-A2-GB20-00 August 1999
Switching Between Screen Work Areas
Select Ctrl-a to switch between the two screen work areas to perform all screen
functions.
"
Procedure
To access the screen function area below the dotted line:
1. Press Ctrl-a to switch from the screen area to the screen function key area
below the dotted line.
2. Select either the function’s designated (underlined) character or press the
Tab key until you reach the desired function key.
Example:
To save the current screen, type s or S ( Save ).
3. Press Enter.
4. To return to the screen area above the dotted line, press Ctrl-a again.
Î
Î
ÎÎ
ÎÎ
main/config/network Hotwire
Model: 79xx
NETWORK INTERFACE OPTIONS
Margin Threshold: –3db
Excessive Error Rate Threshold: 1E–6
AutoRate: Disable
DSL Line Rate: 1552 Kbps
Payload Rate: 1536 Kbps
Circuit Identifier: Clear
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Ctrl-a to access these functions, ESC for previous menu MainMenu Exit
Save
Ending an ATI Session
Use the Exit function key from any screen to terminate the session.
"
Procedure
To end a session with the asynchronous terminal interface:
1. Press Ctrl-a to go to the screen function key area below the dotted line.
2. Save changes if required. A confirmation message appears if you have made
but not saved changes to your configuration.
3. Tab to Exit (or type e or E) and press Enter.