Paradyne FrameSaver 9720, User Manual, Page: 26 / 340

2. User and Command Line Interfaces, and Basic Operation
2-2
December 2002 9700-A2-GB20-20
Logging On
Start a session using one of the following methods:
Telnet session via:
— An in-band management channel through the frame relay network (frame
relay network service provider).
— An in-band management channel through the ATM network (DSL
provider).
— A local in-band management channel configured on the DTE port between
the FrameSaver DSL CSU/DSU and a router (V.35 units only).
— An Ethernet LAN port.
Dial-in connection using an external modem.
Direct terminal connection over the COM port.
If no security was set up or security was disabled, the Main Menu screen appears
(see the example in
Main Menu on page 2-4). You can begin your session.
If security was set up and is enabled, you are prompted for a login. Enter your login
ID and password.
When the user interface has been idle, the device times out and the session is
automatically ended; the screen goes blank. Press Enter to reactivate the
interface.
If your login was . . . Then the . . .
Valid Main Menu appears. Begin your session.
NOTE: If your login is valid, but access is denied, there are
two currently active sessions.
Invalid Message,
Invalid Password
, appears on line 24, and
the Login screen is redisplayed.
After three unsuccessful attempts:
A Telnet session is closed.
The User Interface Idle screen appears for a directly
connected terminal or modem.
An external modem is disconnected.
An SNMP trap is generated.
Access is denied.
See your system administrator to verify your login (Login
ID/Password combination).