68
Chapter 5
Using Whitepine Exodus with Existing Hardware
The following procedures should be amended to Chapter 5 of the installation manual:
•
Installing the Whitepine Exodus software package with EtherLink II Card
•
Installing the NMS Full-Feature Workstation Application software with EtherLink II Card
•
Installing Whitepine Exodus software package with a StarLAN 10 NAU
•
Installing the NMS Full-Feature Workstation Application software with
StarLAN 10 NAU
•
Network configuration of full-feature workstation
For installing the Token Ring software on the Full-Feature Workstation, see Token Ring
Installation When Using Either X-One or Exodus Software
at the end of this section
.
Installing the Whitepine Exodus Software Package with EtherLink II Card
To install the Whitepine Exodus software package, perform the following steps:
1. Insert the Whitepine Exodus installation disk into the drive and
TYPE:
A:install
PRESS:
Enter
2. The system prompts:
Enter the floppy drive to use [A:]:
PRESS:
Enter
3. The system prompts:
Enter the destination drive to use [C:]:
PRESS:
Enter
4. The system prompts:
Enter the destination directory to use [\EXODUS]:
PRESS:
Enter
If the directory, C:\EXODUS, does not exist the system prompts:
The directory C:\EXODUS does not exist. OK to create it? (y/n) [y]
TYPE:
y
PRESS:
Enter
