56
Using the Globalyst 520 and 575 As a Full-Feature Workstation
Running eXceed 4 Software
This section discusses using the Globalyst 520 as a full-feature workstation. It also provides
installation instructions and configuration information for using the Globalyst 520 and the
Globalyst 575 running eXceed 4 software. Load and configure the Globalyst machines for eXceed
4 software using the procedures in the following order.
1. Perform the procedures in one of the following sections depending on the Globalyst
hardware being used:
•
Configuring the Globalyst 575 as a Full-Feature Workstation to Run eXceed 4
•
Configuring the Globalyst 520 as a Full-Feature Workstation to Run eXceed 4
2. Install the SuperTCP Version 4.0 software.
3. Install the eXceed 4 software.
4. Configure the SuperTCP and eXceed 4 software.
Configuring the Globalyst 575 As a Full-Feature Workstation to Run eXceed 4
To configure a Globalyst 575, perform procedures in the following sections in the order shown:
1. Changing the Globalyst 575 Display Option for Windows.
NOTE
After changing the display option, you should exit windows and edit
your
Autoexec.bat file to remove the win entry. This will allow the
system to boot up at the DOS prompt instead of automatically
invoking Windows.
2. Switching Off Cache on the Globalyst 575.
3. Configuring the EtherExpress Card; for Token Ring networks, refer to the Changing the
Token Ring Configuration section in your COMSPHERE 6800 Series Network
Management System Installation and Maintenance Guide.
Changing the Globalyst 575 Display Option for Windows
To change the display option, perform the following steps:
1. Insert the diskette labeled Miro High Speed Drivers for Windows 1 of 2 into the a: drive.
2. Select
Run from the Program Manager’s File menu.
3. Type
a:\install in the Run Dialog box and click on OK.
4. Select
English from the list of language selections in the welcome dialog box and click on
OK.
