Paradyne BitStorm 2400, User Manual

Page: 74 / 90

B. SNMP Traps
B-2
December 2002 2400-A2-GB20-10
Cold Start Warning External power cycle (hardware reset) of
the device has occurred. RFC 1907
Warm Start Warning The system is resting due to a power
disruption of the reset command. RFC 1907
Table B-2. SNMP Traps – BitStorm 2400 Events
Event Trap Description MIB
Upstream rate
below threshold Event to notify that the maximum upstream
rate has dropped below the rate-limiting
threshold. eloopCOMdmUpstreamSpeedLow
Downstream rate
below threshold Event to notify that the maximum
downstream rate has dropped below the
rate-limiting threshold. eloopCOMdmDownstreamSpeedLow
Clear modem
stats A request to set
eloopCOModemIfClearStats to clear(2) has
been received. eloopCOModemIfClearStatsEvent
Modem reset A request to set eloopCOMdmDeviceReset
to reset(2) has been received. eloopCOModemIfResetEvent
Modem
training/port
reset A request to set eloopCOMdmIfResetTrng
to reset(2) has been received or a set on
the Spectrum Mgr mode caused a reset
port. eloopCOModemIfResetPortEvent
Table B-3. SNMP Traps – CPE Modems Events
Event Trap Description MIB
Modem down The CPE modem Ethernet interface is
down. eloopCPEModemEnetLinkDown
Modem up The CPE modem Ethernet interface is up. eloopCPEModemEnetLinkUp
Clear modem
stats A request to set
eloopCPEModemClearStats to clear(2) has
been received. eloopCPEModemClearStatsEvent
Reset modem A request to set eloopCPEModemReset to
reset(2) has been received. eloopCPEModemResetEvent
Table B-1. SNMP Traps – Shelf Events (2 of 2)
Event Trap Description (Object) MIB