Pandora Smart Moto, Manual

Page: 32 / 56

32 PANDORA SMAR T MOTO PLUS
Writing a mobile device to the system memory
When approaching the vehicle or when Internet connection is missing a mobile phone with the
mobile application Pandora Connect installed can work with the system via a Bluetooth connection.
This type of connection allows you to control the system, receive status information and use your
mobile phone as an authorization device.
!
T
HE SYSTEM SUPPORTS
B
LUETOOTH CONNECTION ONLY WITH ONE MOBILE DEVICE
. T
HE SETTINGS FOR USING THE MOBILE DEVICE AS AN
OWNER AUTHORIZATION DEVICE ARE MADE BY A QUALIFIED TECHNICIAN
.
I. ENTER THE PROGRAMMING MODE
Use the VALET button to enter the «Service PIN-code» (default value is 1-1-1-1). See the detailed
instruction of code entering in the «Control over the system in case of emergency» section.
II. ENTER THE «PAIRING A MOBILE PHONE» PROGRAMMING LEVEL
After entering programming mode, press and hold the VALET button for 5 seconds (until the fifth
signal of the Siren). The system will enter the «Pairing a mobile phone» programming level. The LED
indicator will light green, the system is ready for pairing
!
T
HE PREVIOUSLY PAIRED DEVICE WILL BE ERASED FROM THE SYSTEM MEMORY AFTER ENTERING THE LEVEL
III. PAIR A MOBILE DEVICE
Enable the Bluetooth connection in the mobile device, enter the app settings, click «Bluetooth
control», click «Not defined». In the search box, establish a connection with the detected system. The
red and green flashes of the «LED» indicator light and a single siren sound will confirm the pairing.
!
I
F THERE IS NO AUTOMATIC PAIRING
,
ENABLE THE
«PIN
REQUEST FOR PHONE PAIRING
»
ITEM IN THE
«R
ADIO TAG AND MOBILE DEVICE
FUNCTIONS
»
SETTINGS AND MAKE THE PAIRING PROCEDURE AGAIN
. A
MOBILE DEVICE WILL REQUEST A
PIN-
CODE
(F
ACTORY PRE
-
SET
IS
0-0-1-1-1-1
WHERE
4
LAST DIGITS ARE THE
«S
ERVICE
PIN-
CODE
». T
HIS SETTING SHOULD BE MADE BY A QUALIFIED TECHNICIAN
.
IV. EXIT PROGRAMMING MODE
Turn on the ignition and then turn off to exit programming mode.