Pando PHTV-942, User Manual

Page: 278 / 360

14
CHANGING THE OVEN LIGHT BULB
The replacement bulb must withstand
temperatures up to 300 ºC. You can order
them from the Technical Assistance Service
Department.
Changing the upper bulb
To substitute the light bulb, proceed as
follows:
1. Disconnect the oven from the power
supply. Take the plug out of the socket or
2. Loose and remove the glass light cover
(1) .
3. Remove the bulb (2) . Warning! The bulb
may be very hot.
4. Fit a new G9 230V / 25W bulb. Warning!
Do not touch the light bulb surface
directly with your fingers because you
may damage the bulb.
Follow the lamp
5. Tighten the glass light cover into place (1) .
6. Connect the oven again to the power
supply.
Trouble shooting
This section describes some of the most fre-
quent problems that can affect your oven, along with the most common causes and
possible solutions.
The oven stops working
•
Check the power connection.
•
Check the fuses and the circuit breaker of
your installation.
•
Make sure the timer is either in the manual
or programmed setting.
•
Check the position of the control and
temperature dial.
The inside light does not go on
•
Change the bulb.
•
Check it has been properly installed as set
out in the Installation Instructions.
Nothing happens when the keys are
pressed
•
Check if the Safety Block is active.
The heating pilot light does not turn on
•
Select a temperature.
•
Select a setting.
•
It should only come on while the oven is
heating up to the selected temperature.
Oven smoking during use
•
Normal during first use.
•
Clean the oven regularly.
•
Reduce the amount of fat or oil in the tray.
•
Do not cook at temperatures higher than
those indicated in the cooking chart.
The expected cooking results are not
achieved
•
Check the cooking charts for guidance on
how your oven operates.
My accessories and shelf supports are
damaged
•
You must replace them and remove them
during subsequent cleaning cycles.
The enamel color has changed or stains
have appeared
•
The chemical composition of some food-
stuffs may cause changes in the enamel.
•
This is normal and does not damage the
properties of the enamel.
Make sure the oven has been
disconnected from the mains before
changing the bulb.